|
|
This miniature 8 step adjustable
hand crimping tool produces an 8 indent crimp configuration
and will 2 crimp wire sizes 18 AWG (1.0mm ) 2 through 32 AWG
(0.3mm )
|
| To crimp wire size 18 AWG 2 (1.0mm
), order contact positioner 2 2 9502-11. To crimp wire size
AWG (0.5mm ) through 30 AWG (0.05mm ) order contact positioner
9502-5. Each positioner is equipped with a data plate which
gives the correct crimp-depth setting for each wire size and
must be used with 9507 tool frame for best results when crimping
Rhapso - D Series contacts. |
Insertion/Removal Tool (M81969/1-02)
 |
One end of this tool is used to insert contacts
into Rhapso - D Series connectors. The other end is used to
extract contacts. This is accomplished by sliding the extraction
tip down the wire into the connector until it bottoms against
the contacts. A slight rotation while pushing will release the
contacts, which are then extracted by simultaneously pulling
on the wire. |
|
